68Marine
Feb 25, 2010, 10:05 AM
I have a Troy-Bilt portable generator (Model 01919) with a Briggs and Stratton engine (model 204412, Type 0163-E1) using a NIKKI carburetor. Problem: will not start. I checked the oil levels (OK), replaced with fresh fuel, check spark plug (no fuel on it) but still no luck. I removed the carburetor fuel bowl and dropped the float assemble. Bowl was half full of fuel. Cleaned (really no issue) and replaced the float assembly and bowl with a spring between the bottom of the float assembly and bowl (I guess, since the spring was in the bottom of the bowl when I removed). Engine started right away, running low and high revs, and ran for about 5 minutes then stopped. Fuel was dripping from the air breather intake. Repeated the above process but would not start. I'm not sure if the float assembly must go in a certain orientation relative to the underside of the carburetor. The bottom of the carburetor has little holes as does the top of the float assemble - the top of the assembly is a round plastic disk with the same diameter as the bottom of the carburetor. Any help? THANKS
Read more: http://www.justanswer.com/questions/1k4y9-i-have-a-16hp-v-twin-vanguard-on-a-dyna-gen-needs-a-new-carb#ixzz0gZHAW5vn
Read more: http://www.justanswer.com/questions/1k4y9-i-have-a-16hp-v-twin-vanguard-on-a-dyna-gen-needs-a-new-carb#ixzz0gZHAW5vn