PDA

View Full Version : Intermittent ignition on gas furnace


heater306
Jan 14, 2010, 05:13 AM
Furnace model GNJ075N12C1.
Electronic ingition module: SV9500M2682

Furnace works fine most of the time... then enters the start up mode with no light off and locks out. I have found that if I 'giggle' the ignitor connector in the control module the resistance ignitor comes on, temporary pilot lights, then gas flows and lightoff.

Woke up this morning with thermostat set for 65. Temp was 60 with noise (no fan air) coming from furnace. Did the 'giggle' and everything works. I've done this before and it works for a few days then happens again.

heater306
Jan 15, 2010, 08:03 PM
How do you change out the igniter. The unit is in the back of the flame tube and I can't see how to disconnect it.