My 1992 coolant system needs bled out how do I do that

. Set heater slide bar to maximum heat and remove radiator cap.

. Open radiator drain plug (passenger side of radiator) and allow radiator to empty into a suitable pan.

. Replace any deteriorated radiator and heater hoses:

https://www.askmehelpdesk.com/cars-trucks/faq-how-troubleshoot-repair-maintain-hondas-selected-other-vehicles-46563-8.html#post1393743

. Close radiator drain plug and refill with 50/50 mixture of G-05 antifreeze and distilled water, up to the very top of the radiator.

. Open air bleed screw, where the top radiator hose connects to the engine block, until coolant starts to come out. Then, retighten air bleed screw.

. Replace radiator cap, empty overflow reservoir, refill reservoir to the "Full" line with coolant, and replace reservoir hose and cap.

. Start engine and allow the car to reach normal operating temperature. Check for any leaks.

. Allow car to completely cool down and add additional coolant, if necessary, to fill the overflow reservoir to the "Full" line.

Be sure to read the links below:

https://www.askmehelpdesk.com/cars-trucks/faq-how-troubleshoot-repair-maintain-hondas-selected-other-vehicles-46563-7.html#post1365453

https://www.askmehelpdesk.com/cars-trucks/faq-how-troubleshoot-repair-maintain-hondas-selected-other-vehicles-46563-3.html#post235973