mvchurch
Dec 12, 2009, 10:14 AM
I have a DCS 1832 and I am getting intermitting open. The wires at the control panel are tightly secured. It could be a resistor problem and I am unsure of to what the resitor value should be for the zones. Can you help?
Stratmando
Dec 13, 2009, 10:34 AM
Are you sure it uses resistors, if so, are you using Single or Double End of line resistors?
It is 2.2K(2200)Red/red/red for single end of line,
2 5600 ohm resistors for double end of line resistors.
No resistors if EOL's are disabled.
How many ohms do you read on that zone when it is closed?