Any ideas why this system (which is new to me) always goes a degree higher than what it is set for?
Example: I have it set for 16.5 and it goes to 17.5
When I have it set for 17.5 it goes to 18.5

I have it on the +/- 0.3 setting


Thanks for any input...

I guess if you set it to fixed span (+/-0.3C) it will tends to overshoot (particularly if the climate is still not too cold). You may try to set it to 5 cycles/hour mode and it may track the temperature better (but trade-off is more frequent on/off cycling)

I just got one of these, and also noticed that the heat was kicking in while the temperature is still above the set point. I have been busy pushing buttons to try to figure this out. I could be wrong, but I am getting the impression that although you can change the options while in "HEAT" mode, they don't actually "take" unless you switch the mode to "OFF" and back again. So far so good for me...

Another note on this unit. I have set it on Cr 0, which the manual says is +/-0.5 degrees, but it is actually doing +/-0.3 degrees on that setting. Aside from that it is holding the right temperature now. For the record, my options are 24 hr, Cr 0, Fn 0, bL 1, rE 1, CO 9, SY 0.

Now that it is working, I love this unit. It does everything I could want and more! I especially like the auto vent feature, although I am still trying to figure out how often and how long it runs the fan.

It will turn on the fan for several minutes (5 ?) if there is no activities in the past hour.

Another note on this unit. I have set it on Cr 0, which the manual says is +/-0.5 degrees, but it is actually doing +/-0.3 degrees on that setting. Aside from that it is holding the right temperature now. For the record, my options are 24 hr, Cr 0, Fn 0, bL 1, rE 1, CO 9, SY 0.

Now that it is working, I love this unit. It does everything I could want and more! I especially like the auto vent feature, although I am still trying to figure out how often and how long it runs the fan.

What type of setup do you have with those settings. I just installed this unit last fall and the heat worked great but now the A/C is not kicking on. I am using a forced air gas furnace and a single phase HVAC. They are both older models it that helps. Anyway, the fan outside does not come on and I don't hear the compressor working at all and there is no cold air. I can hear the furnace working and the fan working and I am getting air but it's not cold at all.

I have white attached to W for heating
Green attached to G for the fan to work
Red attached to RC>>jumped>>RH
And Black attached to Y for the cooler

What should my settings be on the thermostat? I feel as I've connected the wires correctly but something is not programmed properly in the NOMA thermostat and it's keeping the air from kicking on and the compressor is not working and the pipes are not cold.