My inside fan isn't running but the unit runs on the outside of the house.

In this thread KC13 recommended putting the heat or cool wire on the PRI-1 connector.
https://www.askmehelpdesk.com/heating-air-conditioning/bryant-90-plus-furnace-burning-smell-no-blower-327491-2.html

I did that and the fan didn't run. So I'm assuming that's the problem.

My model # is 350mav036060fgka.

What part(s) exactly do I need?

Anyone? Is my troubleshooting correct? Is it the fan?

Check for power to fan, if it is receiving 120v, and not turning, check the capacitor, if cap is good, then yes, sounds like a bad motor.

I realized I had done the self test shorting the com24 and test terminals. Did that and the fan kicked on.

So maybe the capacitor. Where is it? How do I test it?

Found the capacitor and removed it.

It was the cap. Thanks!

Glad you got it fixed. Take care.