joe_swan
Jun 13, 2009, 01:20 PM
I just replaced an old mercury stat with this programmable Honeywell RTH230B. I have a 4 wire cable that was coming in to the mercury stat with the following colors:
Red, Blue, White, Green
I have it wired up as best I could. The heat works fine. When I try to turn the AC on, the fan turns on, but the outside AC unit does not. I have checked the breaker box outside and it is good. It worked fine just before this.
Here is a link to the installation instructions for my new stat. There is a jumper running from Rh to Rc.
A specific question: Does the Red wire go to the Rh or the Rc?
Any other info on why this is happening would be appreciated. Thanks!
Red, Blue, White, Green
I have it wired up as best I could. The heat works fine. When I try to turn the AC on, the fan turns on, but the outside AC unit does not. I have checked the breaker box outside and it is good. It worked fine just before this.
Here is a link to the installation instructions for my new stat. There is a jumper running from Rh to Rc.
A specific question: Does the Red wire go to the Rh or the Rc?
Any other info on why this is happening would be appreciated. Thanks!