sled
May 24, 2009, 07:50 AM
We just got this dryer from my girl friends boss. Whirlpool Senseon Dryer model# GEW9868KQ0 it had been sitting for over a yr but worked when they upgraded. We brought it home and I had to convert it from 4 prong 220 to 3 prong 220. When I plugged unit in it worked, could hear old dust rattling around and the feet were off balance. I leaned the dryer forward while I unscrewed the feet but dryer was still on at first. The cord pulled out while doing so and naturally the unit turned off. We were able to level the unit but when I plugged it back in and tried to turn it on again. Nothing. No power, the display isn't lit up at all, will not turn on when you hold any buttons down? Checked if outlet still has power and it does (welded for about 4 hours after)
Things I have done include checked outlet for power like mentioned above, attempted to check door switch. There is no indicator lighting up showing that it is open, I physically held it shut to see if that was the problem still nothing. And I tried to unscrew to bypass just in case switch is completely bad but the intentions seemed easier than the task turned out to be so I'm putting it back. I have tried to research, search for similar problems, seems mine is a little unique. Only found problems on thermal switches needed replaced. I'm actually thinking its something with the display. If it isn't getting any power or is bad then it wouldn't be able to tell the unit to turn on?
Things I have done include checked outlet for power like mentioned above, attempted to check door switch. There is no indicator lighting up showing that it is open, I physically held it shut to see if that was the problem still nothing. And I tried to unscrew to bypass just in case switch is completely bad but the intentions seemed easier than the task turned out to be so I'm putting it back. I have tried to research, search for similar problems, seems mine is a little unique. Only found problems on thermal switches needed replaced. I'm actually thinking its something with the display. If it isn't getting any power or is bad then it wouldn't be able to tell the unit to turn on?