Wends
Mar 9, 2009, 10:37 PM
Hi,
I would like to put a sink in the basement. I took out the plumbed in bathroom (done by the previous owner) which was tied into the drain at the terminal end of the vent stack which consisted of a toilet along with a sink and a shower running off the same drain (in that order); the sink was vented with a free standing 2' x 1 1/2 " pipe which was capped by a chrome device, venting right into the basement (is this a cheater vent?)
Can I drain the sink back into the ABS drain that was put in, since it is already coupled into the ceramic drain that emerges from the terminal end of the vent stack? How can I vent the sink without cutting into the cast iron vent stack at the basement level? Can I go up to the ceiling of the first floor where the second floor bathroom sink ties into the cast iron stack? Or can I go out the basement wall and vent it there with a cheater vent? The kitchen sink doesn't seem to have a vent, is this because it is a double sink?
The vent stack is at the back of the house and the sink I would like to install is 12' away from this
There is another ceramic drain (5" O.D.) that runs at about a 30 degree angle from the vent stack but heads out the back of the house through the foundation wall. This pipe slopes toward the front of the house, a floor drain branches into this immediately followed by a p-trap, it then continues on to the next floor drain (I think- I haven't followed it beyond the first floor drain which I encountered- by the angle and direction that it is heading in) What is this drain?
Is the drain from the latter mentioned pipe the main drain or is it the one leading from the vent stack? Or will I find later on that they both tie into each other as they head toward the front of the house?
What is the relevance of a wet and a dry stack?
And what or how can you tell the difference?
I know I ask a lot.
Cheers Wendy
I would like to put a sink in the basement. I took out the plumbed in bathroom (done by the previous owner) which was tied into the drain at the terminal end of the vent stack which consisted of a toilet along with a sink and a shower running off the same drain (in that order); the sink was vented with a free standing 2' x 1 1/2 " pipe which was capped by a chrome device, venting right into the basement (is this a cheater vent?)
Can I drain the sink back into the ABS drain that was put in, since it is already coupled into the ceramic drain that emerges from the terminal end of the vent stack? How can I vent the sink without cutting into the cast iron vent stack at the basement level? Can I go up to the ceiling of the first floor where the second floor bathroom sink ties into the cast iron stack? Or can I go out the basement wall and vent it there with a cheater vent? The kitchen sink doesn't seem to have a vent, is this because it is a double sink?
The vent stack is at the back of the house and the sink I would like to install is 12' away from this
There is another ceramic drain (5" O.D.) that runs at about a 30 degree angle from the vent stack but heads out the back of the house through the foundation wall. This pipe slopes toward the front of the house, a floor drain branches into this immediately followed by a p-trap, it then continues on to the next floor drain (I think- I haven't followed it beyond the first floor drain which I encountered- by the angle and direction that it is heading in) What is this drain?
Is the drain from the latter mentioned pipe the main drain or is it the one leading from the vent stack? Or will I find later on that they both tie into each other as they head toward the front of the house?
What is the relevance of a wet and a dry stack?
And what or how can you tell the difference?
I know I ask a lot.
Cheers Wendy