I have a Dyna-Glo Kerosene (RMC-95-C2) heater,

After attempting to change out the wick, I installed raised and it wouldn't lower. So I took it back apart. When I went to raise itagain, It would not. It doesn't click and immediately falls back to extinguished position. I haven't even attempted putting the wick back on until I get it to click and stay up..

Any Ideas?

This is the same heater but the company name has changed. See page 9-10 for wick replacement

http://www.yourheater.com/DH2301-3%20owners%20manual.pdf

I figured it out, the auto extinguish part was bent, thus not allowing the ratchet part on the turn dial to catch on the bottom parts of the extinguisher.

Thanks, didn't expect a response that quick

Glad you got it going.