PDA

View Full Version : Toilet running, flapper not seating


thetha
Jan 7, 2009, 08:13 AM
I recently had a new system put in my toilet with a flapper. The toilet kept emptying a little and then would fill up at intervals during the day. I told my plumber about it and he came and replaced the flapper. We're on the second flapper and the toilet is still running. It seems the flapper isn't seating right. We already tried the vaseline. Are there different sizes for flappers?

It's just annoying and I'd like to fix it myself without having the plumber come back. Thanks for any help you can give me.

21boat
Jan 7, 2009, 08:31 AM
Many times where the flapper sits on the tank seal the concave seal gets a very small amount of slime and grime. I usually use wet sand paper or 000 fine steel wool to clean this up so the flapper seals beveled edge sits better and seals. Vaseline is not correcting the problem. The worst scenario is take the tank of and replace that piece that's goes trough the tank and its new on new. Many times the new flapper will work for awhile and its rubber gets a little hard and the seat it sits on makes it fail sooner than it should. Try the wet sandpaper and lightly sand the tanks beveled seat the flapper sits in
Flappers are standard one size. There are different looks about them but size is standard
Signed 21 Boat

If I Helped To Answer Your Question Please Rate My Answer

afaroo
Jan 7, 2009, 06:17 PM
Check the flush valve. Most likely the new flapper is not sitting against the old flush valve assembly. We almost always replace flapper AND flush valve assembly at the same time to reduce chances of call backs!

Fluid master sells an entire tank replacement kit... includes all of the above plus a new fill valve for about $18.00 see the Image below. Good Luck.

John

thetha
Jan 9, 2009, 08:55 AM
Check the flush valve. Most likely the new flapper is not sitting against the old flush valve assembly. We almost always replace flapper AND flush valve assembly at the same time to reduce chances of call backs!

Fluid master sells an entire tank replacement kit...includes all of the above plus a new fill valve for about $18.00 see the Image below. Good Luck.

John

Hi John

Thanks for your reply to my problem. The plumber installed the entire fluidmaster kit plus two flappers and the toilet is still running!! I don't know anything about plumbing and don't want to screw up my toilet. The other day I turned off the water in the bathroom before I went to bed. In the morning when I went to check it the water was down a little in the tank. Does that mean I have a leak somewhere? Or is the flapper just not sitting right?

afaroo
Jan 9, 2009, 07:28 PM
OK if you are losing water in tank then it is defiantly the flapper valve issue either it is a wrong type or it is not seating properly or it is not adjusted properly you need to call the same plumber to come and fix it for you, Good Luck.

John

thetha
Jan 11, 2009, 03:13 PM
OK if you are loosing water in tank then it is defiantly the flapper valve issue either it is a wrong type or it is not seating properly or it is not adjusted properly you need to call the same plumber to come and fix it for you, Good Luck.

John

Thanks a lot for your help :-))

ballengerb1
Jan 11, 2009, 06:17 PM
Lets face it , your plumber does know jack. The fluidmaster 400a is not a complete toilet kit but a complete kit will contain a 400a plus a new overflow pipe and flush valve. It it was all replaced and it still leaks do not pay this plumber a penny. My guys tell me Rau Charles can install a fluidmaster at midnight with no leaks.

afaroo
Jan 11, 2009, 08:35 PM
I agree with Bob, you should call the plumber back to fix your problem, Good Luck.

John