PDA

View Full Version : Bathtub drain plug screw


sgdevries
Dec 29, 2008, 07:53 PM
I am trying to remove the drain plug from my bathtub to make it easier to unclog. I have removed the top cap of the plug to expose a screw. I cannot get this screw loose. Is there a trick?

twinkiedooter
Dec 29, 2008, 08:14 PM
Yes, there is a trick to these plugs. The easiest way to unclog a tub drain is to use a ZipIt. It's a long (15") piece of flat plastic around 1" wide that has little barbs on the plastic piece. This is the best thing I have ever used to unclog a bathtub drain as I have very long hair and every time I wash my hair it gets clogged in the tub drain. No need to totally remove the tub drain screw or you might not get it back in again. This costs about $3-$4 at WallyWorld.

letmetellu
Dec 29, 2008, 08:22 PM
If you have a lift and turn type drain plug, the screw should come out if you let the drain down and then try to unscrew the screw.

KISS
Dec 29, 2008, 09:26 PM
You snake the bathtub drains through the overflow, not the drain in the bottom of the tub otherwise the snake doesn't get anywhere.

afaroo
Dec 29, 2008, 11:52 PM
I agree with Keepitsimplestupid,

Snake it from the tub waste and overflow, (see image). Unscrew and remove the overflow plate, (The one with the drain lever) and pull out the tub stopper if you have one. Feed the cable (1/4" best or 3/3" with a small tip. You can rent a Ridged K50 sink cable.) About 2' down you will run into the bend of the trap. Crank and push at the same time to work around it. Your blockage will be found in the lateral pipe going to the stack. You shouldn't have to put out more then 10 or 12 feet. We have found tub and shower clogs to be mostly hair and the worm should auger into it and pull it back, good Luck.

John

speedball1
Dec 30, 2008, 08:53 AM
I am trying to remove the drain plug from my bathtub to make it easier to unclog. I have removed the top cap of the plug to expose a screw. I cannot get this screw loose. Is there a trick?

Is this the stopper that you have? (see image) Let me know. Tom

sgdevries
Dec 30, 2008, 01:23 PM
Is this the stopper that you have?, (see image) Let me know. Tom

No, on mine the top nipple of the plug turned off easily and there is a large screw going straight down the drain. It is not a lift and turn plug, it stays open just by lifting it. I could not find a set screw like in the picture.

speedball1
Jan 1, 2009, 07:42 AM
No, on mine the top nipple of the plug turned off easily and there is a large screw going straight down the drain. It is not a lift and turn plug, it stays open just by lifting it. I could not find a set screw like in the picture.

Any of these fit the discription? (see images) Cheers, Tom

sgdevries
Jan 1, 2009, 11:05 AM
Any of these fit the discription? (see images) Cheers, Tom

The picture second from the right is the closest; the knob on top turns off exposing the head of a brass screw. This is the screw I can not loosen.

speedball1
Jan 2, 2009, 06:29 AM
The picture second from the right is the closest; the knob on top turns off exposing the head of a brass screw. This is the screw I can not loosen.

Put a pair of vice grips on that brass screw and turn it out counterclockwise.
Good luck, Tom