I have a carrier gaspak M#48SS048080311. The inducer moter comes on then the gas valve opens and I have flame for 5-15 seconds then it goes out. The trouble shooting code links it to the inducer motor. Any Ideas?

I have a carrier gaspak M#48SS048080311. The inducer moter comes on then the gas valve opens and I have flame for 5-15 seconds then it goes out. The trouble shooting code links it to the inducer motor. Any Ideas?


Could be the inducer motor end switch if so equipped. It could be the flame sensor if so equipped. The model number you posted is not in my book.

Could be the inducer motor end switch if so equiped. It could be the flame sensor if so equiped. The model number you posted is not in my book.
I think you might be right about the end switch. There is a sensor there with three wires that go back to the control board. Probably not sensing the motor turning thanks.