PDA

View Full Version : Burner flame engages on glow rod then kicks off


LucyLou1
Dec 19, 2008, 03:24 PM
http://www.lucylou.com/

The glow rod is glowing, the flame engages across flow rod for approximately 3-4 seconds but the other four burners do no light (when I blow air on the flame it pushes the flame to the other burners & the burners stay for for a whole running cycle but will NOT engage for a second cycle. The light indicator code on the box reads: PRESSURE SWITCH STUCK OPEN. (Yes, the small blower is running):(

KC13
Dec 19, 2008, 04:05 PM
The burners will likely have to be removed and cleaned to restore flame carry-over during ignition. Pressure switch fault is odd if the unit is attempting to ignite.