RegisLine
Nov 6, 2008, 05:02 PM
I just hooked up a VisionPRO 8000 Series Tstat. Everything lit up and seemed to be working last night. Today I got curious and turned the heat up to 85 degrees, and no heat was coming out of my registers. I called Honeywell and since I'm not a "Pro" they would not help me. The old thermostat was a Janitrol with the wiring as follows:
Y - Yellow
G - Green
R - Red
O - Black
W2 - White
C - Blue
So I hooked up the Vision 8000 as follows
R- Red
O/B - Black
Y - Yellow
G - Green
C - blue
Aux - White
I have a heat pump on my system, so I wired it as according to the wire diagram. I did not have it set in the "installers menu" to Electric Furnace in program 0180, but then I turned it on, and it still did not work. Any suggestions would be greatly appreciated. I hooked up the old Tstat for now until I can get a clear answer. I don't want to mess anything up, and it is Nov. so its getting a little cold out. Thanks for all the help in advance!
Y - Yellow
G - Green
R - Red
O - Black
W2 - White
C - Blue
So I hooked up the Vision 8000 as follows
R- Red
O/B - Black
Y - Yellow
G - Green
C - blue
Aux - White
I have a heat pump on my system, so I wired it as according to the wire diagram. I did not have it set in the "installers menu" to Electric Furnace in program 0180, but then I turned it on, and it still did not work. Any suggestions would be greatly appreciated. I hooked up the old Tstat for now until I can get a clear answer. I don't want to mess anything up, and it is Nov. so its getting a little cold out. Thanks for all the help in advance!