I have a goodman electric furnace model A 32-00 I have no heat but the blower comes on runs for about 4-5 minutes then shuts off, I hot wired the ground to the 24 v furnace control wire and the furnace came on and started to put out luke warm air but after replacing thermostat
Again no heat only blower, checked control wire and got about 33 volts from transformer, I believe this is OK ? So is it a sequencer gone bad ?

I have a goodman electric furnace model A 32-00 I have no heat but the blower comes on runs for about 4-5 mins then shuts off, I hot wired the ground to the 24 v furnace control wire and the furnace came on and started to put out luke warm air but after replacing thermostat
again no heat only blower, checked control wire and got about 33 volts from transformer, I believe this is ok ? so is it a sequencer gone bad ?



It is possible a sequencer has gone bad or a heat element. Number 91

http://securenet.goodmanmfg.com/pdf/infoPdf/images/P-513.004.gif

This number A 32-00 is a basic air handler part number. A heater was added to this unit so the part number changes. FYI

Just found out the expensive way,same thing,fan but no heat and shuts off after a few.turned out to simply be a clogged vacumum line from the fan to the limit switch,clean out the nipple on the fan.cost me $196 to find out,hope this will save $$