PDA

View Full Version : 19hp briggs new carb and stalls


bigdaddy931
Jun 3, 2006, 01:36 PM
Hi all new to the fourum I have a question I hope you all can help. I have a murray lawn tractor with a 19 hp briggs. I put a new carb on it and the tractor runs but stalls under a load like it is running out of fuel. When I inspected the carb the bowl was full of gas and clean. The mechanic I took it too said that the motor is bad that the valves were sticking this don't sound right because it runs fine till you go to cut with it and eventually it stalls. I figure it's a fuel issue due to the fact I can keep the motor running with starter fluid and eventually it will catch again and run on it's own fuel help please.

thebriggsdude
Jun 3, 2006, 08:49 PM
Doesn't have a fuel pump?

If not, then its just gravity fed then... make sure your getting good fuel flow to the carb. Did you install a new carb hoping it would solve this?

bigdaddy931
Jun 4, 2006, 04:56 AM
Hopefully when I get the machine home today I will be able to go over everytihng if you can think of anything else I would appreciate it.

thebriggsdude
Jun 4, 2006, 12:44 PM
Well even with the fuel pump, make sure its getting good flow.