I recently bought a White Rogers 90 series BLUE. It might be over kill for what I need it for. Anyway I took out the old T-stat. It's a 2 wire white was on the W and the black was on the R. My wife is on my case. Help

Joe

Exact model number?

1F95-1277 I wanted a programmable t stat. little over kill

Make sure you have fresh batterys.
Make sure you follow and adjust all items in the INSTALLER/CONFIGURATION MENU.

Use RH Power for Heating
Use W/E Heat Relay/Emergency Heat Relay (Stage 1)

Here is a copy of your directions


http://www.white-rodgers.com/wrdhom/pdfs/instruction_sheets/0037-6753.pdf

Wiring diagrams

http://www.white-rodgers.com/wrdhom/pdfs/instruction_sheets/0037-6808.pdf

NOTE you can leave the factory jumper in between RH and RC if so equipped.

You have a very fancy thermostat for such a simple job. I hope it works out for you.

Got a good deal on it. I used the black on RH and the white on the W/E. Set it as a Single stage. Still not working. Sorry to bother

Joe

If you set the controls up exactly as mentioned in the thermostat program it should work.

With this thermostat no C or common is necessary so it should be working. Does the screen light up?
Are the battery installed correctly?
Are the batterys know to be good not just guessing that they are good?

The thermostat depends upon batterys for proper operation since there is NO C wire.

Are you sure you have power going to the system? If you remove the thermostat and jumper the two wires will the heat run? If your heat runs your thermostat is set up wrong or its bad. If it doesn't work after you jump the wires you may have a high or low voltage problem.

WOW,, where you live Boulder?In WV its been 95 degrees for the last 4 days,, my furnace won`t run either at these temps