New_Tech
Aug 28, 2008, 01:20 PM
Hi
I have a top loading 110 series Kenmore washer. I replaced its coupler and it was laying on its side for almost one week till that coupler arrived. I also tried to separate drum from coupler which was not successful. So I removed motor from bottom and replaced coupler.
Now it works fine but at high spin cycle it jumps and walks in the room. It is on hard surface and I have leveled it too but nothing worked.
Its washer drum is very loose and looks like sitting on springs only.
Any suggestions or expert advice will be appreciated. I have done lots of other stuff but this is my first time messing with washer.
I have a top loading 110 series Kenmore washer. I replaced its coupler and it was laying on its side for almost one week till that coupler arrived. I also tried to separate drum from coupler which was not successful. So I removed motor from bottom and replaced coupler.
Now it works fine but at high spin cycle it jumps and walks in the room. It is on hard surface and I have leveled it too but nothing worked.
Its washer drum is very loose and looks like sitting on springs only.
Any suggestions or expert advice will be appreciated. I have done lots of other stuff but this is my first time messing with washer.