2.3 engine solinoid relay on fender clicks when try to start low voltage

Check to make certain the terminals are clean and tight at both ends of both of the battery cables.

Make sure the clutch is fully depressed... if so it will complete the circuit.

If not there is a switch WAY UP under the dash on the passenger side.. a safety cutoff

In case of an accident... this can also be switched by a foot of a passenger .

It happened to my Ranger... reset and drive on.

I'm having the same problum but with a chevey truck 1991 model and I have tryde cleaning and titening things up but I bident thank about the battery next time when I go to were my truck is I'm going to try it. If it doesn't work I am going to go crazzy lol