Hello,I am changing a motor on a older ford riding lawn mower,It is a 16 hp twin and I'm putting a newer 16 hp twin on it(both briggs) The newer one has a fuel solenoid and the older doesn't ,I am wondering where do I have to tie in the solenoid too? The newer motor also has a govener the older doesn't ,does it matter? I can supply both engine#'s if someone needs them for reference
New motor model -303777
Type -0332-01
Code -92061611
(other #) -1880

Old motor
Model-402707
Type -0138-01
Code- 83120712


Any help or additional advice would be much appreciated! Thanks

Anyone?

anyone?
Patience is of the virtue. There are a lot of questions to be answered daily or as soon as we can in our "spare" time.

Now then, the best solution for you is to remove the fuel solenoid and replace it with the bolt from the other carb if it will fit. And see if the engine will run without the fuel solenoid.

Thanks and sorry(I see it is a very busy froum)

No bowl on the other carb,anyone know where I can tie the wire in?

Actually in case anyone runs across a similar problem or wants to bypass the solenoid.I drilled the movable plunger out so it does not shut off the fuel.