johnb2
Apr 16, 2008, 07:52 AM
I keep blowing fuzes after only a few seconds of operation.
I put in a new 15 amp fuze and the mower will start and run about 5 to 10 seconds before the fuze burns out.
I've place a test ligt between the battery ground and can't detect a short when the enging switch is off.
I've tried a 20 amp fuze but that burns out the ignition switch, wihich I replaced twice.
How can I find what is causing this problem?
I put in a new 15 amp fuze and the mower will start and run about 5 to 10 seconds before the fuze burns out.
I've place a test ligt between the battery ground and can't detect a short when the enging switch is off.
I've tried a 20 amp fuze but that burns out the ignition switch, wihich I replaced twice.
How can I find what is causing this problem?