PDA

View Full Version : Still no fire on a honda


ontracmotors
Mar 29, 2008, 10:51 AM
Step by step. I followed all the steps and still no fire . Everything is correct but no fire. What else tx grease monkey?

TxGreaseMonkey
Mar 29, 2008, 01:15 PM
If you are positive the ICM, coil, fuses, and CEL are good, I would focus on the distributor housing--internal sensors may be bad. I would only buy a genuine Honda distributor housing and install the old ICM and coil.

ontracmotors
Mar 29, 2008, 01:38 PM
I put in a new distributor from honda . Same problem

ontracmotors
Mar 29, 2008, 01:38 PM
What now? Can you call me?

TxGreaseMonkey
Mar 29, 2008, 02:41 PM
Does your CEL come on and go off after 2 seconds, when the ignition switch is turned to Position II? Do you hear the main relay click and the fuel pump run, during this 2 second interval? Be sure to test all under-dash fuses with a test light or multimeter, particularly the ACG (S) (ALT) fuse. Have you checked the ignition switch?

Tell me what you've done. Are the ICM and coil new, as well as the distributor housing?