Hi I have a 95 civic 1.6 that idles up and down and I can't figure it out

See if this helps:

Idle speed is controlled by the Idle Air Control Valve (IACV). The IACV changes the amount of air being bypassed to the intake manifold, in response to electric current controlled by the ECM. When the IACV is activated, the valve opens to maintain proper idle speed.

Symptom and Subsystems to Check:

1. Difficult to start engine, when cold--check Fast Idle Thermo Valve.

2. Fast idle out of spec, when cold:
a. Check Fast Idle Thermo Valve.
b. Check IACV.
c. Check idle adjusting screw (see Section C).

3. Rough idle:
a. Check hoses and connections.
b. Check IACV.

4. RPM too high, when warm:
a. Check IACV.
b. Check Fast Idle Thermo Valve.
c. Check hoses and connections, check Power Steering Pressure Switch Signal, and check idle adjusting screw.

5. RPM too low, when warm:
a. Idle speed is below specified rpm, with no load--check IACV and idle adjusting screw.
b. Idle speed doesn't increase after initial start up--check IACV.
c. Idle speed drops in gear (automatic transmission)--check automatic transaxle gear position switch signal.
d. Idle speed drops when AC is on--check air conditioning signal and IACV.
e. Idle speed drops when steering wheel is turned--check power steering pressure switch signal and IACV.
f. Idle speed fluctuates with electrical load--check hoses and connections, IACV, and Alternator FR Signal.

6. Frequent stalling, while warming up--check IACV and idle adjusting screw.

7. Frequent stalling, after warming up--check idle adjusting screw and IACV.



Additional Steps:

. Check Alternator FR Signal. Have alternator inspected, if idle speed fluctuates with electrical load. The FR signal communicates to the ECM how "hard" the alternator is working to meet the electrical demands of the car, including the battery and any loads which aren't monitored by the ELD. This square-wave signal varies in pulse width, according to the load on the alternator. The ECM places, approximately, 5 reference volts on the wire. The voltage regulator will drop this signal to approximately 1.2 volts, in proportion to alternator load. The ECM compares the electrical load (ELD) signal with the FR (Charging Rate) signal from the alternator and uses that information to set the idle speed and turn the alternator on and off. This helps fuel economy.

. Clean main ECM ground on thermostat housing.

. Reset ECM, by removing the 7.5 amp Back Up Fuse, in the under-hood fuse box, for 10 seconds.

. Replace PCV Valve, cleaning hose with brake cleaner spray.

. Substitute a known-good ECM. If symptom goes away, replace original ECM.