Hello there. I have a question about replacing an old honeywell dial thermostat with a new Honeywell Thermostat model rth230b. I have a red, green and white wire. So far, I have it programmed, and hooked up this way... I put the red wire in the Rh, Rc, empty, White in W, and Green in G, y empty. I have hot water heat and no AC. I was just wondering if I had this hooked up correctly! I have never done anything like this before! Thank you in advance!

You have to jump RHand RC for the fan to work on the fan switch depending on your desire. See pages 1/4 and 2/4 for a explanation of this.

Link to manual on line.


http://customer.honeywell.com/techlit/pdf/69-0000s/69-1800.pdf

Thank you!