I have a Mira Event shower unit which has broken down and I need to replace it. However I cannot for the life of me get the hot and cold water feedpipes out. The shower unit has the push in type facility - that is you (in theory) just push the pipes in and they seal. Hopefully this is fine as the new shower unit that I have has the same fitting but how do you get the pipes out once they are in there? Any advice appreciated!

Hey nogood... I think this will help. It is the instruction/installation manual for these valves.

www.taps4less.co.uk/pdf/mira%20Event%20XS.pdf

If it does please RATE THIS ANSWER by clicking on rate this answer at top right. Thank you.