elf5735
Jan 13, 2006, 03:43 PM
Today I had to repair a copper water pipe in my basement and had to shut off the well and water pump. I did so by unplugging the power cord from the pressure swithc to the wall outlet and then drained the system of water. Once my pressure switch dial read zero (0) I completed the repair (copper sweating, flux, solder, etc).
I plugged the power switch back into the 220 outlet and the dial continues to stay on zero which means there is no water pressure and NO WATER. How do I reset, or prime, the system to get water flowing again and a reading on the pressure gauge?
I plugged the power switch back into the 220 outlet and the dial continues to stay on zero which means there is no water pressure and NO WATER. How do I reset, or prime, the system to get water flowing again and a reading on the pressure gauge?