poochielavegas
Jan 8, 2008, 03:42 PM
I recently purchased two Harbor Breeze Bellhaven fans.. I used 14 gauge wire with 15 amp circuit.. The wire was used in the past for a heater/light in my bathroom, which I replaced including the wiring. So I used the old wiring for the new fans I installed.
I purchased two Harbor Breeze switches having a light dimmer and speed control for the fan on them. I wired everything, but nothing worked. I realized the switches were bad, replaced those, but nothing works.
I then tried to take all switches out and replace with a single toggle switch ON/OFF and tried the fan and light by the pull switch.. Nothing... The switch, fan and light section are all getting power because I tested it with a tester.
Then I thought maybe the first wall switch possibly shorted out the fan and purchased another fan, but it still doesn't work... All sections are receiving power.
Just for info I used one main power line for both switches, I pigtailed off the main power to power both switches.
Anybody with any suggestions would be extremely appreciated.
I purchased two Harbor Breeze switches having a light dimmer and speed control for the fan on them. I wired everything, but nothing worked. I realized the switches were bad, replaced those, but nothing works.
I then tried to take all switches out and replace with a single toggle switch ON/OFF and tried the fan and light by the pull switch.. Nothing... The switch, fan and light section are all getting power because I tested it with a tester.
Then I thought maybe the first wall switch possibly shorted out the fan and purchased another fan, but it still doesn't work... All sections are receiving power.
Just for info I used one main power line for both switches, I pigtailed off the main power to power both switches.
Anybody with any suggestions would be extremely appreciated.