Anyone know the rheem criterion 2 (RDGD 05MAUER) , if so could you see my post with pictures on here

https://www.askmehelpdesk.com/heating-air-conditioning/heater-fine-daytime-stops-night-159346-new.html

I can't figure this out, all the details there if u browse over the posts and reply there. Thanks to anyone for help:)

You are supposed to keep all your posts on the same link.

((thanks t-top, it does glow fine. Could it be glowing fine but still have a problem with being too sensitive for monitoring the flame from age?))

This had been around the block many times.
All the help and ideas have been given you.
I suggest you buy the ignitor/flame sensor and install it. (the item that glows)

This is not a real expensive part and it just might take care of your situation.
These parts do not last that long any way so you would be replacing it eventually.
NOTE: Do not touch the end that glows with your hand. Avoid that at all costs. The oil on your skin will cause the new part to burn out in short order.

Let us know how it turns out after you replace that part.

You are supposed to keep all your posts on the same link.

((thanks t-top, it does glow fine. could it be glowing fine but still have a problem with being too sensitive for monitoring the flame from age?))

This had been around the block many times.
All the help and ideas have been given you.
I suggest you buy the ignitor/flame sensor and install it. (the item that glows)

This is not a real expensive part and it just might take care of your situation.
These parts do not last that long any way so you would be replacing it eventually.
NOTE: Do not touch the end that glows with your hand. Avoid that at all costs. The oil on your skin will cause the new part to burn out in short order.

Let us know how it turns out after you replace that part.

Thanks for first thing I can try, do you know a parts distrib in Los Angeles area? I tried locals but no luck...

You are supposed to keep all your posts on the same link.

((thanks t-top, it does glow fine. could it be glowing fine but still have a problem with being too sensitive for monitoring the flame from age?))

This had been around the block many times.
All the help and ideas have been given you.
I suggest you buy the ignitor/flame sensor and install it. (the item that glows)

This is not a real expensive part and it just might take care of your situation.
These parts do not last that long any way so you would be replacing it eventually.
NOTE: Do not touch the end that glows with your hand. Avoid that at all costs. The oil on your skin will cause the new part to burn out in short order.

Let us know how it turns out after you replace that part.

Ps- I couldn't figure out how to change my post title since it's not actually correct so I made this one, apologies for any mistake

I have no idea of any parts dealers in Cal.
You will probably have to buy at a HVAC shop OR Ebay.