View Full Version : Removing old metal toilet flange
doneatsix
Nov 10, 2007, 01:22 PM
How do I remove or replace a old toilet flange that is attached to a 4" cast iron drain pipe enbedded in a concrete floor?
NO_NAME
Nov 10, 2007, 03:41 PM
How do I remove or replace a old toilet flange that is attached to a 4" cast iron drain pipe enbedded in a concrete floor?
Most likely it is soldered in place in which case you will have to apply heat via a propane or oxy acetylene unit. Without actually seeing it that is the best I can do for you. Try "Ask A Handyman" if that is not a solution for you. Just put those two words in your search tool and voilà you will be there. They respond right away and be as specific as you can, remember that they cannot see it either.
plumberjames83
Nov 10, 2007, 10:44 PM
Or chipping it out with a jack hammer had to do that be4
speedball1
Nov 11, 2007, 11:05 AM
Most likely it is soldered in place in which case you will have to apply heat via a propane or oxy acetylene unit. Without actually seeing it that is the best I can do for you. WRONG! It's not soldered in.
This is a cast iron flange secured by a lead and oakum poured and caulked joint. To remove a poured lead and oakum joint take a 3/8" drill bit and drill a few holes down past the lead and into the oakum.. Push a screwdriver under the lead ring and lever it up. Once it's free you can began to peel the lead ring out. Now pick out the oakum and you can pull the joint apart and remove the flange. Good luck, Tom
plumberjames83
Nov 12, 2007, 05:32 PM
See you can learn a lot from this old man (talking about speedball)
LauraKippner
Dec 29, 2012, 08:19 PM
I’m not a plumber myself, so I can’t say I have personal experience or anything, but I have a few friends who are plumbers, and all of them swear by the Flange-Out tool. It’s a drill attachment that makes removing a toilet flange a piece of cake. This is the website for it, in case you want to see it - http://www.flangekutsystems.com/ Like I said, I haven’t used it myself, but from what my plumber friends have told me, it works really, really well!
afaroo
Dec 29, 2012, 08:55 PM
Hello LauraKippner
Welcome to the AMHD website and sharing your thoughts with us but you have responded to a 5 years old thread, always check the date on the left top corner of the post, Happy New Year, Thanks.
John