PDA

View Full Version : 12.5 hp BS not starting


Murray rider
Oct 8, 2007, 04:20 PM
I've been noticing the starter making a very loud screeching noise every time I started it. The noise would last about 3-6 seconds and then it would start. Now, it sounds like the starter is just spinning and not attempting to turn the engine over. Does this sound like it needs a new starter?


Thanks

mrfly
Oct 8, 2007, 05:39 PM
Sounds like it needs a new starter drive

RichardBondMan
Oct 8, 2007, 05:50 PM
I am not a mechanic but yes it sounds like either the starter or the cellenoid.

Murray rider
Oct 8, 2007, 06:11 PM
sounds like it needs a new starter drive


Thanks for the fast response! Can I replace just the starter drive or do I need to buy a complete starter?

RichardBondMan
Oct 8, 2007, 06:16 PM
I am not a mechanic but try Sears.com, but first lift the seat, get the complete model number like 917.XXXXXX, click on parts, enter the model number and see if you can see both the parts listing and an exploded picture of the starter, cellenoid. That may lead you to an answer.

mrfly
Oct 9, 2007, 05:30 PM
You can just replace the starter drive

MOWERMAN2468
Oct 9, 2007, 06:37 PM
Thanks for the fast response! Can I replace just the starter drive or do I need to buy a complete starter?
You can purchase the kit for the starter bendix gear. It is much cheaper than a starter, and is an easy repair. And this problem you are describing has nothing to do with the SOLENOID (correct spelling of solenoid). The bendix gear is made of a neoprene type nylon material, that is designed to wear down and be replaced versus replacing the ring gear on the bottom side of the flywheel, now that is a little more of a job.