View Full Version : How do I install a vent on basement slop sink?
 
 John Da
Sep 8, 2007, 11:13 AM
I have to replace a very old slop sink in basement. It has 1 1/2" Galv pipe for drain, but it isn't vented. I am changing because my washer drains to it and has over flowed a few times,but always flows poorly. There is no clop in line,as I have snaked,but didn't help. I will be using solid PVC. If I tie drain to tee,and extend pipe 3 feet high,WILL THIS WORK? Thanks John :confused:
 Flying Blue Eagle
Sep 8, 2007, 12:17 PM
John , they make a under counter vent  that you can try . If that don't work  CUT the drain line and put ay then a 45 then a pice about 6 or 7 ft high use 1and 1/2 or 2 in pvc pipe. You can any of these parts at a plumbing store or Lowe's, home depot.   Hope I could help
 John Da
Sep 9, 2007, 11:23 AM
FLYING EAGLE -----------   I never heard of the under counter vent??  Where would I look for this at?   Do either of these vents need to go to the outside?   I do not want to do that. Thanks a lot John Da  :)
 stew_1962
Sep 9, 2007, 11:26 AM
They are called a studor vent or air admittance valve.  Don't need to go outside.
 John Da
Sep 9, 2007, 11:31 AM
Stew   1962----------  Do I have to go to plumbing supply house??   Is it PVC?   Thanks :)
 stew_1962
Sep 9, 2007, 11:32 AM
They are PVC, you should be able to buy one at Lowe's, Home depot, etc.
 John Da
Sep 9, 2007, 11:40 AM
THANKS STEW!!   MY HOME DEPOT IN NJ probably  won't have it, not much in plumbing dept. I will try Lowe's, if some one knows what it is.   Does it come in 1 1/2"?
 stew_1962
Sep 9, 2007, 11:42 AM
STUDOR (R) inVENTive Technology (TM) - Air Admittance Valves (http://www.studor.com/mini-vent.htm)
 John Da
Sep 9, 2007, 11:48 AM
STEW  Thanks  A LOT
 John Da
Sep 9, 2007, 12:05 PM
STEW 1962 ----   I seem to be having problem with 1 1/2" galv close nipple that is going into a 4" saddle in my cast iron sewer main.  Can I sawzal the top of nipple just below old tee ?  I f so Do they make something to go over threaded nipple?  Fenco?   I don't want to reduce it going into main.
 stew_1962
Sep 9, 2007, 12:36 PM
I don't recommend ferco-ing over top of old stuff.  You really need to use the fittings and adapters as they were intended, they might work... but only for a while.
 
Is the nipple stuck?  You might be able to judiciously use a dremel tool or a chisel to split the old nipple.  I've spent hours and hours getting old pipes apart - the fix only takes about 5 minutes afterward.  Seems anti-climactic, but the results are always long-lasting.
 
If you have a digital camera, maybe a picture will help get some suggestions for the fix.  There's LOTS of good plumbers on here.
 John Da
Sep 10, 2007, 03:26 PM
Thanks to Everyone's Advice !!    Job Is Completed   :D