PDA

View Full Version : Frigidaire Dryer Bearing or Roller?


firestalker
Aug 21, 2007, 05:53 PM
I have a Frigidaire dryer about 7 YO it has started to allow clothes to get stuck between the drum and the bottom of the outer opening. They get stuck which ruins them leaving a burn mark on the clothes. If I reach inside the drum I can push the front up about 1 inch which closed the gap where the clothes get pinched.

My question is do you think the rear bearing or the rollers are worn out allowing the drum to have slop in it or might it be another problem.

Thanks Gary

jetmen
Apr 21, 2008, 08:33 PM
Gary,
I think you need to read this:
Partselect.com - Frigidaire Dryer Parts And All Brands of Appliance Parts (http://www.partselect.com/xq/aspx/Inventory.470317/qx/PartDetail.htm?SourceCode=6)
And consider replacing the Drum Glide - Top but do not stop there you may also need to replace the Seal-Basket Lower:
Partselect.com - Frigidaire Dryer Parts And All Brands of Appliance Parts (http://www.partselect.com/PartDetail.aspx?Inventory=460194)
Good Luck, Joe