Please can somebody help me I carnt find my users manual for my bush TV and I want to tune in a video without doing it on scart

You're going to at least have to tell us what model of TV you have Tracy. There are tonnes of different models of TV's and each one will have different ways and remotes for tuning it in.

I would also try the Bush website. Do you have anything telling you what that is? I couldn't find it myself.

I've had a look and carnt find anything with a bush website the TV is a 28 '' with screen TV the numbers on the back af the TV are as follows Bush 28zka ws6667 do you need the serial number as well if so it is 0121e1086 :p

iv had a look and carnt find anything with a bush website the tv is a 28 '' wid screen tv the numbers on the back af the tv are as follows Bush 28zka ws6667 do you need the serial number as well if so it is 0121e1086 :p

What is the Brand, usually shown on the front of the unit. I couldn't find any reference to a Bush brandname for TVs so I suspect the brand is something different. The closest I could come is a manufacturer of TV stands (furniture).

I did Google the model numbers as you posted and that did come back with several sites that may help you.

Bush is the brand Scott. Must be a British brand. I'll try looking on a few search engines for a ""Bush 28ZKA". I suggest you do the same. Little tip when searching - try "Bush 28ZKA -george" (without the quotes). Without the "-george" you're bound to get a lot of George Bush pages in there.

This forum might be a good place to ask - http://www.tv-forums.com/forum/TV_Equipment_C4/TV_Repair_Forum_F3/

Thanks guys I've tried looking on Google found a website emailed some people with a bush TV had no reply yet

Hi,

Your remote should have the number 4400 ?

Press and HOLD the menu button for at least 2 seconds.

The audio menu will be displayed followed by the overview menu.

Select number eleven by keying in the number one key twice - or select a higher number.

The channel curor will move to number eleven from number one.

Press and HOLD the WHITE (Index) button for at least 2 seconds.

The word BUSY appears below the menu and starts station search.

Stations will be stored in received order. BUSY will change to READY.

To regroup the stations into your preferred order:
Press P+ or P- button to select the station you wish to change into position one.

Press GREEN button. The bottom section of the menu turns green to indicate ready to change.

Press number one key and after a few seconds the channel curor will move to position one from its previous position. Press GREEN button again to confirm the change.

Select the next programme which you want to change (to position two). Do this by pressing the two relevant numerical buttons such as one followed by four for fourteen.

Press GREEN.

Press number two key, the channel cursor will move to position two. Press GREEN to confirm the change.

Follow the same steps to reposition the remaining programme positions.

PLEASE NOTE that when changing the position of programmes (as per above) the changes MUST be completed in order, starting from 1, the 2, 3, 4, etc.
Therefore you may either end up with the VCR as channel one, or you may prefer to leave it at the default number that it is automatically allocated to (which would be a double diget such as 10, 11, 12 etc.).
Most video recorders have an option to 'send' a tuner signal (often one or two black bars). If yours offers this, I suggest that you use it as it will make recognising the vcr channel easier during setup.


:) Geoff

Thanks geoff your instuctions worked a treat my video is up and running a great big thanks :) :) :) :o

You are most welcome.

I am pleased that you let me know yhat it worked. :)