Hello,

I have an Elite model dishwasher that was installed August 2006. It worked fine until about May 1, 2007. Since then it starts a wash cycle, runs for about 1-2 minutes, and then stops. After about 6 hours, the dishwasher finally shows washing is complete, but no washing or rinsing took place. Sears service tech came and said the water temp was too low. It is set at 140 deg. Installation instructions say water heater shold be set to 120 deg.

Any ideas?

Thanks.

None, but get Sears back before the warranty expires in Aug, 07. Might ask for another dishwasher. I believe I would.