This will be my first time to do this. I heard you should fold the tape over the end and roll it inward in the club or do you overlap it. Do you have pics

This will be my first time to do this. I heard you should fold the tape over the end and roll it inward in the club or do you overlap it. Do you have pics





YES :cool:

I'm a club builder at golf mart. You usually want about 1/2" to an 1" of tape past the butt end of the club. Twist the overlapping tape into a little pig tale and push it into the back of the club, then slide on grip with solvent or some other lubricant.

Or you can use lighter fluid. How I do it is spirl wrap the tape onto the shaft, twist & tuck into the butt of club. I then take the grip, use my finger to cover the small hole at the top of the grip, put 1-2 squeezes of lighter fluid in the grip, then cover the opening with your other finger so when you shake up the lighter fliud inside the shaft, the fluid won't splash out. Then w/ you finger still on the little hole, put all the excess fliud on the tape you just wrapped. Make sure you cover it completely. Then slide the shaft on. If it is a spiral shaft, when putting it on, you twist it on so the tape doesn't bunch up.