I'm trying to fix the heater on my dryer (see https://www.askmehelpdesk.com/appliances/no-heat-dryer-790093.html). I was advised to use a multi-meter to test continuity. But frankly, I haven't used it in years and am not sure of the settings. I've attached a picture. Can anyone tell me where the leads should plug in?

Balck lead goes into the DC port. Leave the red one where it is to measure OHMS.

After properly attaching leads, touch the tips of the leads together. The needle should move to zero on the ohms scale, (far right). If needle does not got to zero, adjust with the ohms adjustment knob or wheel (upper left).

Looks my old one was dead. Got a new one and it appears the high threshold thermostat is bad, the others are OK.

Scott, to keep from going back in the dryer change all the safeties at the same time. They can be purchased in a kit for less than $50. Good luck.

Yes I ordered a kit

Looks my old one was dead. Got a new one and it appears the high threshold thermostat is bad, the others are OK.

How did you determine it had failed?

How did you determine it had failed?

Which? The multi-meter or the thermostat?

The multi-meter because it wouldn't register anything when I touched the leads together. The thermostat because my new multi-meter registered nothing when I touched the leads to the contacts, However it did register the other one.

Comparing the old part to the new part is a perfect way to make this determination. The fact that you tested the part after you had the replacement is great. So many people just change parts and hope it works. Now you know what was needed.