I purchased a Instant Hot water faucet that has three pipes coming out from the base. One goes to the source and the other two go to the tank. I am trying to connect to a Kohler Instant Hot tank. This is the same tank as the Insinkerator Instant Hot tank. The tank has three places to connect a pipe not two... one is a vent. I am having a difficult time making this work.

Any thoughts?

Dave

A picture would be helpful. Back to you, Tom

InSinkErator | Installing and Instant Hot Water Dispenser (http://www.insinkerator.com/en-us/Service-Support/Dispenser-Support/Pages/Dispenser-Installation.aspx)

See if this is your set up.

One is Water In, Second one is How Water out, Third one is Vent or Overflow... Each tube should have different way of attaching to the tank and should be in 3 different hose sizes... So it should not be so hard to figure it out. Did you try to read Instructions ? Back to you. Milo