View Full Version : Using a 5/8" steel elbow with 5/8" copper tubing
Rudolph Jackson
Jan 14, 2014, 02:56 AM
The 5/8"dia. copper elbow that was soldered to the 5/8" dia. Copper tubing sprung hole in it. I went to a plumming store for a solution to he problem an he sold me a 5/8" dia. Steel elbow with the ferrules to use. It seems too heavy to me o use. Is this combination okay?
parttime
Jan 14, 2014, 04:25 AM
Sounds like you have a compression fitting and that should work. Can you post a picture of what you have? There will be an expert along for more help. Hang tight.
massplumber2008
Jan 14, 2014, 05:01 AM
Sounds like a compression fitting to me, too guys (see image)! If the copper tubing and fitting are rigid and hard to move you may also need a compression coupling or two!
I would, however, think a SHARKBITE or GATORBITE push on type fitting would be a better set up here, but you did not say what the copper tube goes too, Rudolph??
More info. needed...
Mark
hkstroud
Jan 14, 2014, 06:42 AM
More info. needed...
Agree. Is this a concealed location? Are we really talking 5/8". Or are we talking 1/2" which measures 5/8 on the outside?
ballengerb1
Jan 14, 2014, 01:09 PM
Why not use cooper, simple enough and any plumbing supply shop wuld have the correct part. Steel and copper plumbing parts can't touch so is this a dielectric fiiting or what
ma0641
Jan 14, 2014, 03:55 PM
Use a brass elbow.
ballengerb1
Jan 14, 2014, 04:06 PM
It is so simple, unsweat the old elbow, clean off the old solder and sweat the new elbow. Cheaper than brass.