PROBLEM: No spark out of Coil. :(

The two large wires going into the Coil have 12 voits when the ignition is turned on.

Replaced Coil and spark plug wires.

Coil is warm to touch after a few attempts at starting.

Still don't have any voltage coming out of the coil.

Tried adding a extra wire from Batter - to engine, suspected a poor engine ground. But no effect.

What is third wire going into coil, it is black and white?

Any ideas??

Thanks

Don't forget to check relays very carefully in fusebox under hood. Also all the grounding screws holding them down.

I would check Voltage out of Ignition Switch.
White Constant 12 Volts
Black/White Starter
Ignition Black/Yellow
(The Black Yellow is the Important One).
If you have a White/Black, that would be Ignition 2.
Good Luck.

The connections are on the left side of the steering column, have to remove a piece of plastic, Have seen many that have the Ignition Switch Connector, directly above the fuse Panel, look for the colors.

This is a 2005 posting.

Hope they got it fixed??
Don't know how I missed it?