I have a State Select electric water heater (M/N ES630DOLSG) that was not heating water. Then I was told A/C on top wet the electrical component and tripped the circuit breaker. Now its all dried out and breaker stays on but no water when faucets are turned to hot water side... all faucets and dishwasher not having any water. How do I reset? So the water heater will fill with water to heat and distribute? Thank you thank you

Did someone close the cold water input valve to the water heater?

Turn off power and re-do wiring because it must have burned a wire in two. That would be the common sense approach. Also, check the water valves. You may need to clean it out. They fill up with sand and scale and should be cleaned out before they quit working.