probablecause
Dec 10, 2012, 04:40 PM
My delta 1700 is leaking so I ordered a replacement kit which arrived fine and with a basic blown up schematic (and that's it).
How do you replace the springs and rubber washers on the inside of the brass housing (the one in the wall)? Do I just pop them out with a dental type pic/tool? Do they just press back in?
Also, the delta instructions are multi use for either the 1700 or the 1500/1300. The problem is it says to discard two of the 4 washers that came with my kit if I am have the 1700 series. This is fine but all 4 washers are very similar in size and the delta instructions don't say how to discern between the two (smaller or larger).
Any suggestions?
How do you replace the springs and rubber washers on the inside of the brass housing (the one in the wall)? Do I just pop them out with a dental type pic/tool? Do they just press back in?
Also, the delta instructions are multi use for either the 1700 or the 1500/1300. The problem is it says to discard two of the 4 washers that came with my kit if I am have the 1700 series. This is fine but all 4 washers are very similar in size and the delta instructions don't say how to discern between the two (smaller or larger).
Any suggestions?