Log in

View Full Version : Rushing Water Sounds in Plumbing


rludolph
Feb 28, 2007, 10:12 AM
I have been experiencing intermittent rushing water sounds in one specific location in my plumbing. I used to get this, which sounds exactly like my sprinkler system turning on (even when it is not), only occasionally. Last night, it started making the noise every 5-10 minutes. The rushing sound lasts for only 1 to 5 seconds. It is coming from inside the wall behind my washer. I tried turning off the valve to the washer, but it still happens. The noise is not in the washer or the valve, but inside the wall.

The noise is most obvious at night, when no water is running in the house except for the water heater and ice maker for the fridge. Can you help?

Ken 297
Feb 28, 2007, 10:28 AM
It sounds as if you have a leak in a toilet. When the level in the toilet tank drops the valve will open automatically and you will hear water running.
Other places I have found similar leaks are on auto filling valves that are on the humidifier on the furnace or a fridge that has an ice cube maker.
If you are on City water and have a water meter you can check to see if the dial on the meter is moving. This will confirm a leak.
There are many ways to check for leaks and if you can't find anything obvious I'll give you some more ideas.

rludolph
Feb 28, 2007, 11:04 AM
It sounds as if you have a leak in a toilet. When the level in the toilet tank drops the valve will open automatically and you will hear water running.
Other places I have found similar leaks are on auto filling valves that are on the humidifier on the furnace or a fridge that has an ice cube maker.
If you are on City water and have a water meter you can check to see if the dial on the meter is moving. This will confirm a leak.
There are many ways to check for leaks and if you can't find anything obvious I'll give you some more ideas.


Thanks Ken 297. The noise sounds just like a leaking toilet, but I have checked them all. When I have had toilet leaks in the past, the sound can be traced back to that location. The sound I have now is in the wall, not near any toilet or the fridge. I don't see any leaks anywhere, but will check the water meter to look for a moving dial as you recommend. I guess the leak could occur to the outside without being obvious.

Ken 297
Feb 28, 2007, 04:00 PM
rludolph
If you shut off the water by the valve at the meter for a minute and if you have a slow leak when you turn it on you should hear a rush of water.
It doesn't sound like a leak in the pipe or it would be continuous.

JeanWallace
Mar 2, 2007, 08:25 PM
rludolph
If you shut off the water by the valve at the meter for a minute and if you have a slow leak when you turn it on you should hear a rush of water.
It doesn't sound like a leak in the pipe or it would be continuous.


If there is a leak in a pipe and you turned al the water valves off. would you stll hear the leak or hissing sound? thank you

speedball1
Mar 3, 2007, 09:14 AM
Hi Jean

"If there is a leak in a pipe and you turned al the water valves off. would you stll hear the leak or hissing sound? thank you"

Yes, there would still be pressure in the line until you opened a faucet to relieve it. The sound would continue until the pressure bled off. Regards, Tom

doug238
Mar 3, 2007, 10:17 PM
A valve not opened all the way can make a rushing sound.

rludolph
Mar 18, 2007, 09:20 AM
Thanks for all the feedback. Turns out that the problem was so apparent that one night because there was a house fire in our subdivision. I guess the water pressure was fluctuating wildly.

I later did a check of the water pressure in my house and found that it was over 100psi. I had the pressure valve changed out, which reduced the PSI to 40-50 and eliminated the puzzling noise.

atw58
Jul 8, 2013, 06:50 PM
Same here. It was driving my wife crazy. I put a water pressure meter on the laundry room tap. Every 5-6 min, the pressure would drop from 50 psi to 40 then quickly ramps up to 70 and falls back to 50.

doug238
Jul 10, 2013, 07:51 PM
If your pressure was fluctuating that shows you do not have a closed system, meaning there is not a check valve at the meter or the check valve the municipality provides has failed. After you have a closed system [check valve installed] then you are required to have an expansion device installed.