tucsontim
Apr 5, 2012, 03:27 PM
I have installed a GE Z-wave on/off relay switch.
There are four connections, the black load line, black hot line, white neutral line and green ground line.
The switch is a touch pad type, not a rocker.
When the pad is touched the lights go on and quickly go off. Almost as if the switch itself is acting as a breaker.
I have thoroughly checked all of the connections for tightness, including the ground.
The switch will continually activate the lights for a brief moment similar to a camera taking a flash picture.
Thank you for considering a solution for this problem.
Tim from Temecula
Zw4001
Signal frequency 908.42 MHz
Maxium loads 600W
There are four connections, the black load line, black hot line, white neutral line and green ground line.
The switch is a touch pad type, not a rocker.
When the pad is touched the lights go on and quickly go off. Almost as if the switch itself is acting as a breaker.
I have thoroughly checked all of the connections for tightness, including the ground.
The switch will continually activate the lights for a brief moment similar to a camera taking a flash picture.
Thank you for considering a solution for this problem.
Tim from Temecula
Zw4001
Signal frequency 908.42 MHz
Maxium loads 600W