When I turn the key to position to the engine light stays on, in a earlier ? The light was supposed to go out, is there a problem when it stays on.

The car stalled while driving.1 ckd for power at fuel sending unit- none, replaced the fuel relay, still no start,didn't hear fuel pump run, so I replaced the fuel pump & FILTER still no start.ckd for spark, no spark, replaced the coil no start tested the coil & ignition module getting 4.2 ohms & 1.8-2.0 volts, no start.I ckd starter fuse,acu(?),&ing or ig all look good, what could the problem be. Thanks

When you turn the ignition switch to ON (Position II), does the Check Engine Light (CEL) come on and then go off after 2 seconds? If not, the problem is with the ACG (ALT) (S) fuse, in the under dash fuse/relay box; ECM (perform the K-Test); main relay; or the ignition switch. Perform tests in that order.

Strong chance the ECM is bad.

All ckd out good, I wasn't testing ignition module correctly, had power going to distributor but not going out. I replaced the distributor, it now starts.