I have a Kirkland Dryer and inside the dryer is the plastic device that is suppose to separate the clothes. It has come away from the dryer itself and I am wondering the best way to get that piece attaced again. It screws on, I just need to know if the top of the dryer pops up or if I need to go through the back of the dryer. Any directions would be so helpful, as my laundry is backing up:o

You should see a seam about 1 " below the top surface. Wedge a putty knife or table knife into the seem and try prying up. Move the knife a few inches in each direction and pry again. It should pop up. Be careful inside the housing, there are many sharp edges.

Thank you so much for your help!! My clothes are drying as we speak!