Log in

View Full Version : No hot water in shower and sink in one bathroom only?


lixnix05
Jun 28, 2011, 07:03 AM
We have had this house about a year. Water has worked without a hitch, until about 2 months ago. The spare bedroom, which is used very seldom, no longer has hot water coming out of the sink or shower/bath. Cold works fantastic, but neither sink or shower faucet or showerhead work on hot. It obviously isn't a faucet or showerhead problem. Please help!! (oh, and water heater is only 2 yrs old)

ballengerb1
Jun 28, 2011, 07:21 AM
Start with the sink, get under the cabinet and close the stop for the cold water feed. Now open the faucet and move the handle back and forth from cold to hot a few times, what do you get?

lixnix05
Jun 28, 2011, 09:02 AM
Once I did that, the sink hot water now works. But what about the shower and tub? No change there, and how could I do the same for it?

ballengerb1
Jun 28, 2011, 10:53 AM
I am on the road right now so difficult to answer in detail. Open stop under sink, turn on both hot and cold faucets, what.do you get

massplumber2008
Jun 28, 2011, 11:11 AM
Hi guys...

Tell us is this sink faucet a single handle faucet or a two handle faucet? We can tell you more after that, OK?

Mark

lixnix05
Jun 28, 2011, 09:23 PM
The sink and shower faucet are both single handles. Sink faucet now works hot and cold after closing the cold water valve under sink. Now what do I do with the shower/bath??

ballengerb1
Jun 29, 2011, 08:20 AM
So you can now draw both hot and cold from this faucet with the valve closed under the sink, is that what you mean? This would be very unusual.

massplumber2008
Jun 29, 2011, 01:00 PM
I think what lixnix is saying, Bob is that when he/she uses the single handle lever water comes out when he/she pushes the handle left or right... as you suggested, that would be VERY unusual... ;)

Lixnix, when you shut the cold water shutoff at the sink, did you check the hot and cold water at the shower? If not, shut the cold shutoff at the sink again and turn the shower on to hot water and see if you get hot water (give it a couple minutes to flow right).

If you get hot (and cold) water at the shower while the cold shutoff is shut under the sink then I suspect that the mixing cartridge has failed in the single lever sink faucet and will need to be replaced.

Here, I can't be 100% sure as we cannot isolate the shower to test it (can we? Do you have shutoffs at the shower?), but the easiest place to start is the sink anyway... just replace the entire mixing cartridge and that should resolve everything. If that fails to fix things then the shower mixer cartridge is shot and will need to be replaced, but at this time I doubt it is the shower.

Let us know more here, OK?

Mark