I have a kenmore dryer I dryed a load of cloths it was fine went to do my next load and it won't cut on or do anything I checked the breaker it was fine had a friend check the voltges he said the start button wasn't getting any voltge to it. What could this be would it be the thermal fuse . I'm really lost on this on anyone have any thoughts thanks

My dryer won't run! (http://repair2000.com/norun.html)

See if this helps. Good luck

Your drier's thermal fuse has blown due to a build-up of dirt. You have to disassemble the drier and clean it out by vacuuming the motor and scraping out and washing out all other parts, then replace the thermal fuse located near the heating elements. It is oval with two wires attached and will read zero when tested with an ohm meter. Go on YouTube to learn how to do this. If not done correctly it will cause a fire. DrTom4444