mmkearney1
Apr 25, 2011, 04:49 PM
Failure
Code
Condition
Check/Repair
F01
EEPROM ERROR
A communication error between the Central Control Unit (CCU)
And the EEPROM onboard the CCU occurred.
PUMP DRIVE ERROR
The pump driver fails to activate.
MAIN RELAYS ERROR
One of the main relays is not working properly.
A power glitch may cause this error.
Unplug washer or disconnect power for two minutes.
Verify CCU operation by running a Diagnostic Test or any cycle.
Replace CCU board.
The relay might be soldered or always open.
Replace CCU board.