View Full Version : How to trim the sides of interior hollow doors?
berkebilemike
Dec 13, 2010, 11:51 AM
I have a hollow core door that I purchaed . The purchased door width from factory is 24 " and the door opening is also 24 " (original pre-hung hollow door measures at 23 3/4") . What is method recommended to trim off approx. 1/8 " from each side ?
ma0641
Dec 13, 2010, 12:57 PM
Rent a power planer and set a straightedge along the side to act as a stop. You could possibly use a power saw with a plywood blade and then sand the edge. /8 removal still gives you plenty of edge thickness.
creahands
Dec 13, 2010, 01:04 PM
First choose would be an electric plane. On lock side, adjust plane so u get a slight bevel, about 7 degrees, on side that swings toward door stop.
Second choose a table saw. Will have to sand edge after cut.
Third hand plane.
Good luck
Chuck
creahands
Dec 13, 2010, 01:07 PM
Hi Brian
Sorry about my post. Yours was not up when started
Chuck
ma0641
Dec 13, 2010, 01:49 PM
Happens to me too. At least we're on the same page. I was going to repost with an angle cut but I'll leave that up to your post. Good old minds must think alike! Brian